Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

PROGRAMMING MILEAGE INTO THE PCM
1. Ignition on, engine not running.
2. With the scan tool, erase DTCs.
3. Using a scan tool, program the mileage into the PCM.
4. Start the engine.
5. Allow the engine to reach normal operating temperature.
6. With the scan tool, select View DTCs.
  Does the DTC reset?
  
  Yes
  - Replace and reprogram the Powertrain Control Module in accordance with the Service Information. Refer to MODULE, Powertrain Control , Removal .
  - Refer to POWERTRAIN VERIFICATION TEST and perform the POWERTRAIN VERIFICATION TEST.
  No
  - The mileage has been successfully programmed into the PCM. Test is complete.
  - Refer to POWERTRAIN VERIFICATION TEST and perform the POWERTRAIN VERIFICATION TEST.