Left Axle Seal

WARNING: This page is about a different variant/trim than selected.

NOTE:

Inboard (Left) axle seal replacement requires removal and disassembly of the axle assembly.

Fig 1: Differential And Seal Removal/installation

Courtesy of CHRYSLER LLC

Remove front axle assembly. Refer to Removal .
Drain axle lubricant by turning housing on its side and draining out of left output bore.
Remove differential cover (5) and differential (3). Refer to Fig 1. Remove and discard O-ring seal.
Using Remover (special tool #9664, Remover, Bearing Cup) and Slide Hammer (special tool #C-637, Slide Hammer, Universal), remove left axle seal.