LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Front Axle) >> Fluid >> Standard Procedure >> Standard Procedure - Fluid Fill

Standard Procedure - Fluid Fill

WARNING: This page is about a different variant/trim than selected.
NOTE:

The 175MM FIA Front Axle assembly is designed for 'fill for life' and is not manufactured with a fluid drain plug.

Fig 1: Fluid Fill Plug Location
GC0081451Courtesy of CHRYSLER LLC
  1. Raise and support vehicle. Refer to Hoisting , Standard Procedure .
  2. Remove axle fill plug (1). Refer to Fig 1.
  3. Fill axle with 600ml (0.64 qts.) of Mopar® 75W-90 Synthetic Gear Lubricant. Fluid should be within 3/16 of bottom of fill hole.
scientia non olet · About LEMON Manuals