LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 976 (Powertrain Control Module (Pcm) - Electrical Diagnostics - 68RFE Automatic Transmission - 2500 Hd & 3500 Hd) >> Diagnosis And Testing >> P0218-Transmission High Temperature Operation Activated >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

HIGH TEMPERATURE OPERATION 

NOTE:

This DTC is an informational DTC designed to aid the Technician in diagnosing shift quality complaints.

NOTE:

This DTC indicates that the transmission has been operating in the "Overheat" shift schedule which may generate a customer complaint.

NOTE:

The customer driving patterns may indicate the need for an additional transmission oil cooler.

NOTE:

If the Transmission has experienced a catastrophic failure, the Transmission Cooler must be replaced.

  1. Verify proper Engine cooling system operation which would affect proper transmission operation.
  2. Verify proper operation of the Transmission Bypass Cooler Valve (Thermostat). Refer to COOLER, TRANSMISSION OIL, OPERATION .
  3. Verify the Transmission Cooler and Cooler Lines are not restricted.
  4. Verify proper torque converter clutch operation.
  5. With the scan tool, check the Event Data to help identify the conditions in which the DTC was set.

    Repair 

    • Repair the cause of transmission overheating. Perform the PRELIMINARY CHECKS procedure. Refer to DIAGNOSIS AND TESTING . Make sure to check for any Service Bulletins pertaining to this problem.
    • Perform the 68RFE TRANSMISSION VERIFICATION TEST. Refer to 68RFE TRANSMISSION VERIFICATION TEST .
scientia non olet · About LEMON Manuals