Diagnostic Test
WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN ACTIVE DTC NOTE:
For vehicle communication problems, use the scan tool to refer to the Network Review Screen. The screen depicts a high level view of the vehicle network. Fault and problem areas appear in red. Selecting any of the network components allows access to the source of the problem.
- Turn the ignition on.
- With the scan tool, read DTCs and record on the repair order.
Is the DTC active or pending?
Yes
- Go To 2
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
- U1040-LOST COMMUNICATION WITH BODY CONTROL MODULE (BCM) ALSO ACTIVE
- With the scan tool, read DTCs and record on the repair order.
Is the U1040-LOST COMMUNICATION WITH BODY CONTROL MODULE (BCM) also set?
Yes
- Perform the U1040-LOST COMMUNICATION WITH BODY CONTROL MODULE (BCM) diagnostic procedure. Refer to BODY CONTROL MODULE (BCM) - DIAGNOSTIC CODE INDEX - 2500 HD & 3500 HD article .
No
- Replace and program the Powertrain Control Module (PCM) in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL . Refer to PCM/ECM REPROGRAMMING - GAS .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
- With the scan tool, read DTCs and record on the repair order.