Diagnostic Test

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read the active DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE (P201) ADJUSTABLE PEDALS RELAY DRIVER CIRCUIT FOR A SHORT TO VOLTAGE
1. Turn the ignition off.
2. Disconnect the PDC C5 harness connector.
3. Disconnect the BCM E harness connector.
4. Measure the voltage between ground and the (P201) Adjustable Pedals Relay Driver circuit.
  Is there any voltage present?
  
  Yes
  - Repair the short to voltage in the (P201) Adjustable Pedals Relay Driver circuit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 3
CHECK THE (P201) ADJUSTABLE PEDALS RELAY DRIVER CIRCUIT FOR AN OPEN
1. Measure the resistance of the (P201) Adjustable Pedals Relay Driver circuit between the Adjustable Pedals Relay and the BCM E harness connector.
  Is the resistance below 5.0 Ohms?
  
  Yes
  - Go To 4
  No
  - Repair the open in the (P201) Adjustable Pedals Relay Driver circuit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE BCM FOR CORRECT OPERATION
1. Reconnect the BCM E harness connector.
2. Turn the ignition on.
3. Using a 12-volt test light connected to ground, check the (P201) Adjustable Pedals Relay Driver circuit at the PDC C5 harness connector.
4. With the brakes firmly applied, shift the gear selector into REVERSE.
  Does the test light illuminate?
  
  Yes
  - Replace the PDC in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .