Diagnostic Test
WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN ACTIVE DTC
- Turn the ignition on.
- Turn the Left Turn Lamps on for at least five seconds.
- With the scan tool, read the Body Control Module (BCM) DTCs and record on the repair order.
Is the DTC active?
Yes
- Go To 2
No
- The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- CHECK THE LEFT FRONT LAMP ASSEMBLY
- Turn the Left Turn Lamps off.
- Turn the ignition off.
- Disconnect the Left Front Lamp Assembly harness connector.
- Turn the ignition on.
- Turn the Left Turn Lamps on.
- With the scan tool, read the BCM DTCs.
Is the DTC active?
Yes
- Go To 3
No
- Replace the Left Front Turn Lamp Bulb in accordance with the Service Information. Refer to UNIT, FRONT LAMP, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- CHECK THE (L551) LEFT FRONT LIGHTING FAULT SENSE CIRCUIT FOR A SHORT TO GROUND
- Turn the ignition off.
- Disconnect the BCM C6/F harness connector.
- Check for continuity between ground and the (L551) Left Front Lighting Fault Sense circuit at the Left Front Lamp Assembly harness connector.
Is there continuity between ground and the (L551) Left Front Lighting Fault Sense circuit?
Yes
- Repair the (L551) Left Front Lighting Fault Sense circuit for a short to ground.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Replace the Body Control Module (BCM) accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .