LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 926 (Passive Entry Module (PEM) (Service Information) 2500 Hd & 3500 Hd) >> Antenna, Passive Entry >> Installation >> Door

Antenna, Passive Entry: Installation: Door

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Low Frequency (LF) Antenna
GC0158151Courtesy of CHRYSLER GROUP, LLC
NOTE:

On two door model RAM trucks, the LF antenna is located in the left front door. On four door model RAM trucks, the LF antenna is located in the left rear door. 

  1. Move the LF antenna into position for installation.
  2. Install the two screws that secure the LF antenna to the door.
  3. Reconnect the door wire harness connector (1) to the Low Frequency (LF) antenna connector receptacle.
  4. Install the front door trim panel (for two door model vehicles). Refer to PANEL, DOOR TRIM, INSTALLATION . If vehicle is equipped with four doors, refer to PANEL, REAR DOOR TRIM, INSTALLATION .
  5. Connect the battery cable to the negative battery post.