Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.

CHECK THE POWER AND GROUND CIRCUITS
1. This DTC is set when the Transmission portion of the Powertrain Control Module is initialized while the vehicle is moving down the road in a valid forward gear.
2. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
3. Check all of the Fused B(+), Fused Ignition Switch Output, and ground circuits to the PCM for an intermittent open or short to ground.
4. With the scan tool, check the Event Data to help identify the conditions in which the DTC was set.
  Repair
  - Check all power and ground circuits to the PCM and repair as necessary.
  - Perform the appropriate TRANSMISSION VERIFICATION TEST. Refer to 68RFE TRANSMISSION VERIFICATION TEST .