6.7L Diesel-Dual
WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- If removed, install the generator mounting bracket (2). Tighten bolts (1) 60 N.m (44 ft. lbs.).
- If removed, install the lower generator mounting bracket bolts (1) and tighten to 33 N.m (24 ft. lbs.).
- Install the generator (1). Tighten bolts (2) to 65 N.m (48 ft. lbs.).
- Install B+ terminal eyelet to generator output stud. Tighten nut to 15 N.m (133 in. lbs.).
- Snap the plastic insulator cap (1) onto B+ output terminal.
- Connect the field wire connector (1) into the generator.
- Install the upper radiator hose support bracket. Tighten bolt to 15 N.m (133 in. lbs.).
- Connect the upper radiator hose at the radiator.
- Fill the cooling system. Refer to STANDARD PROCEDURE
.CAUTION:
Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
CAUTION:When installing a serpentine accessory drive belt, the belt must be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or refer to the appropriate belt routing diagram under ACCESSORY DRIVE .
- Install the serpentine drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
- Install the engine cover and fasteners.
- Install the engine oil dipstick.
- Install both negative battery cables.