LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 891 (Emissions Control - 2500 Hd & 3500 Hd) >> Exhaust Gas RECIRCULATION Valve, 6.7L Diesel >> Tube, Exhaust Gas RECIRCULATION (EGR), Crossover >> Installation >> Installation

Tube, Exhaust Gas RECIRCULATION (EGR), Crossover: Installation: Installation

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: EGR Crossover Tube
GC0137182Courtesy of CHRYSLER GROUP, LLC
  1. Clean each end of EGR crossover tube and its connection points of any old gasket material.
  2. Install new gaskets to each end of the EGR crossover tube (2).
  3. Position EGR crossover tube (2) to engine.
  4. Install bolt (5) finger tight at center bottom of EGR crossover tube.
  5. First, tighten EGR tube clamp (1) to 10 N.m (89 in. lbs.) then tighten clamp (3) to 10 N.m (89 in. lbs.).
  6. Tighten bolt (5) to 10 N.m (89 in. lbs.).
  7. Connect the EGR temperature sensor harness connector (4).
    Fig 2: Engine Cover, Bolts & Oil Dipstick
    GC0161582Courtesy of CHRYSLER GROUP, LLC
  8. Install the engine cover (3). Tighten bolts (1) to 10 N.m (89 in. lbs.).
  9. Install the engine oil dipstick (2).
  10. Connect both negative battery cables.
scientia non olet · About LEMON Manuals