LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 889 (Engine Cooling System - 2500 Hd & 3500 Hd) >> Accessory Drive >> Belt, Serpentine >> Removal >> 6.4L - Secondary Generator

6.4L - Secondary Generator

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Care must be used when removing the accessory drive belt. Always wear appropriate eye and hand protection and use extreme caution when working with the belt.

Fig 1: Cutting Secondary Generator Drive Belt
GC0161583Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the negative battery cable.
  2. Raise the vehicle.
  3. Remove the lower fan shroud.
    NOTE:

    The drive belt is a one time use only. If the belt is removed for repairs. It must be replaced with a new belt.

  4. Using care, Cut the secondary generator drive belt.