Actuator, RECIRCULATION Door: Removal: Removal
WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.
- Remove the HVAC housing assembly. Refer to HOUSING, HVAC, REMOVAL .
- Remove the air inlet housing (1) and place it on a workbench. Refer to HOUSING, HVAC, REMOVAL .
- Remove the two screws (2) that secure the recirculation door actuator (3) to the air inlet housing and remove the actuator.