Manifold, Intake: Removal: Removal

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate both negative battery cables.
Remove the EGR crossover tube. Refer to TUBE, EXHAUST GAS RECIRCULATION (EGR), CROSSOVER, REMOVAL .

Fig 1: Wire Harness Retainers
Courtesy of CHRYSLER GROUP, LLC
Detach the wire harness retainers (1) from the shield.

Fig 2: EGR Control Valve Heat Shield & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove nut (1) and bolt (3) and the EGR control valve shield (2).

Fig 3: Clamps, EGR Air Flow Control Valve Wire Harness Connector & CAC Hose
Courtesy of CHRYSLER GROUP, LLC
Loosen clamps (1) and remove the Charge Air Cooler (CAC) hose (3) from the EGR air flow control valve.
Disconnect EGR air flow control valve wire harness connector (2).

Fig 4: EGR Valve & Wire Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the EGR valve wire harness connector (1).

Fig 5: EGR Air Flow Control Valve Location
Courtesy of CHRYSLER GROUP, LLC
Remove bolt and nut securing oil dipstick tube.
Remove bolts (1) and the intake manifold (2).