LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 877 (6.7L Engine (Service Information) 2500 Hd & 3500 Hd) >> Engine Mounting >> Insulator, Engine Mount, Rear >> Removal >> As69RC Automatic

As69RC Automatic

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

If replacing a engine mount/bracket, be certain to inspect all other engine mounts/brackets in the system. Failure to follow this caution may result in damage to the vehicle.

Fig 1: Rear Transmission Mount To Crossmember Nuts
GC0137138Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Position the transmission jack in place.
  3. Remove the rear transmission mount to crossmember nuts (1).
    Fig 2: Rear Transmission Mount & Nuts
    GC0137139Courtesy of CHRYSLER GROUP, LLC
  4. Remove the nuts (4) securing the rear transmission mount.
  5. Using the transmission jack, raise the transmission.
  6. Remove the rear transmission mount (2).
    Fig 3: Transmission Mount Support Bracket Bolts
    GC0137140Courtesy of CHRYSLER GROUP, LLC
  7. With the transmission raised, remove bolts (1) from the transmission mount support bracket to transmission.
    Fig 4: Transmission Side Support Bracket & Bolts
    GC0137141Courtesy of CHRYSLER GROUP, LLC
  8. Remove the bolts (1) and the transmission support bracket (2).
scientia non olet · About LEMON Manuals