Cylinder Head Cover

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Cover, Bolts & Oil Dipstick

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate both negative battery cables.
Remove the engine oil dipstick (2).
Remove bolts (1) and the engine cover (3).

Fig 2: Locating Crankcase Pressure Sensor
Courtesy of CHRYSLER GROUP, LLC
Disconnect the crankcase pressure sensor 1 wire harness connector (7).

Fig 3: Crankcase Pressure Sensor Wire Harness Connector & Clamp
Courtesy of CHRYSLER GROUP, LLC
Disconnect the crankcase pressure sensor 2 wire harness connector (1).

Fig 4: Identifying CCV Tube, Crankcase Pressure Sensor Connector, CCV Oil Drains & Close Crankcase Ventilation (CCV) Cover
Courtesy of CHRYSLER GROUP, LLC
Remove the Closed Crankcase Ventilation (CCV) cover and crankcase breather. Refer to SYSTEM, CLOSED CRANKCASE VENTILATION (CCV), REMOVAL .
Remove the two CCV drains tubes (3) from cylinder head cover.

Fig 5: Cylinder Head Cover & Gasket
Courtesy of CHRYSLER GROUP, LLC
Remove bolts (1) and the cylinder head cover (2).

Fig 6: Injector Harness Connectors
Courtesy of CHRYSLER GROUP, LLC
If necessary, disconnect both fuel injector wire harness connectors (1).

Fig 7: Cylinder Head Cover Gasket
Courtesy of CHRYSLER GROUP, LLC
If necessary, loosen the fuel injector wire harness nuts (1) on the cylinder head cover gasket (2).
If necessary, remove the cylinder head cover gasket (2).