Cover(S), Cylinder Head: Removal: Left

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Battery Cables & Components

Courtesy of CHRYSLER GROUP, LLC

Remove the nut (1) and the negative battery cables (10, 11).
Remove the engine cover.

Fig 2: A/C Compressor
Courtesy of CHRYSLER GROUP, LLC
Remove the oil indicator bolt.
Remove the accessory drive belt.
Disconnect the A/C compressor harness connector.
Remove the A/C compressor (3) from the engine block.

Fig 3: A/C Line Support Bracket
Courtesy of CHRYSLER GROUP, LLC
Separate the A/C line support bracket (2).
Position the A/C compressor aside.

Fig 4: Injectors Harness Connectors & Ignition Coil Harness Connectors
Courtesy of CHRYSLER GROUP, LLC
Disconnect the ignition coil harness connectors (2).
Disconnect the fuel injector harness connectors (1).
Position the engine harness aside.

Fig 5: Removing/Installing Ignition Coil
Courtesy of CHRYSLER GROUP, LLC
Remove the ignition coil retaining bolts.
Remove the ignition coils (1).

Fig 6: Cylinder Head Cover Removal/Tightening Sequence
Courtesy of CHRYSLER GROUP, LLC
Using the sequence shown in illustration, remove the cylinder head cover retaining bolts.

Fig 7: Cylinder Head & Cover
Courtesy of CHRYSLER GROUP, LLC
Remove the cylinder head cover (1).
Clean the sealing surface of the cylinder head (2).

NOTE:

The cylinder head cover gasket may be used again, provided no cuts, tears, or deformation have occurred.