Gas - Left Side

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

If the battery tray is new, transfer the battery spacer from the old tray to the new tray.
Seat the battery tray for installation.

Fig 1: Lower Battery Tray Bolts
Courtesy of CHRYSLER GROUP, LLC
Install the two lower battery tray bolts (1).
Install the left front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .

Fig 2: Battery Tray Bolts
Courtesy of CHRYSLER GROUP, LLC
Install four bolts (1) securing the battery tray to the fender wall.

Fig 3: Support Bracket & Bolt
Courtesy of CHRYSLER GROUP, LLC
Install the three bolts (2) and remove the support bracket (1) behind the headlight.

Fig 4: Radiator Cover Clips
Courtesy of CHRYSLER GROUP, LLC
Install the radiator cover by removing two clips (1).

Fig 5: Harness Retainer
Courtesy of CHRYSLER GROUP, LLC
Install the wire harness retainers (1) to the battery tray assembly including those in the PDC portion of the tray.

Fig 6: Clip
Courtesy of CHRYSLER GROUP, LLC
Install the clips (1) at the PDC base.

Fig 7: Wire Hold Downs
Courtesy of CHRYSLER GROUP, LLC
Clip all wiring harness wire hold downs (1) on the battery tray. There are 6 hold downs.

Fig 8: B+ Cable Bolt
Courtesy of CHRYSLER GROUP, LLC
Install the B+ cable bolt (1) at the PDC.
Install the battery. Refer to BATTERY, INSTALLATION .

Fig 9: Battery Tray Spacer

Courtesy of CHRYSLER GROUP, LLC