LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 872 (Body - Interior & Exterior - 2500 Hd & 3500 Hd) >> Seats >> Cover, Seat Cushion, Rear >> Removal >> Removal

Cover, Seat Cushion, Rear: Removal: Removal

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: J-Straps
GC0085491Courtesy of CHRYSLER GROUP, LLC
NOTE:

It is not necessary to remove the rear seat assembly in order to remove the seat cushion foam and cover.

  1. Place the cushion into the up position.
  2. Disconnect the seat cushion heat mat electrical connector, if equipped.
  3. Release the J-straps (2) and remove the foam/cover (1) from the seat cushion frame.
    Fig 2: Seat Back Hog Rings
    GC0084645Courtesy of CHRYSLER GROUP, LLC
  4. Roll the cover (3) off of the foam (1) and remove the hog rings (2).
  5. Separate the cover from the foam.
  6. Remove the seat cushion frame bolts and remove the seat cushion frame. Refer to SEAT, REAR  .
scientia non olet · About LEMON Manuals