LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 870 (Tires & Wheels (Service Information) 2500 Hd & 3500 Hd) >> Wheels >> Cover, Wheel >> Removal >> Removal

Cover, Wheel: Removal: Removal

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The hub caps must be removed before raising the vehicle off the ground.

NOTE:

You must use the flat end of the hub/cap remover/installer combination tool to pry off the wheel skins. Insert the flat tip completely and using a back and forth motion, loosen the wheel skin. Repeat this procedure around the tire until the wheel skin pops off.

  1. On 2500/3500 single rear wheel (SRW) models, insert a hub/cap remover/installer combination tool using the blade on the end of the tool to pry the cap off in a back and forth motion.
  2. On 3500 models with dual rear wheels (DRW), you must first remove the hub caps. The hub/cap remover/installer combination tool must be inserted in the pry off notch of the rear hub caps.
  3. Position the hub/cap remover/installer combination tool and pull out on the tool firmly. The cap should come off.
    NOTE:

    Failure to use a back and forth motion could damage the wheel skin chrome finish.

  4. The wheel skins can now be removed from the wheel. Use the flat end of the lug nut wrench to pry off the wheel skins. Make sure that the flat end is inserted and use a back and forth motion to remove the wheel skin.
  5. On 3500 models front hub caps use the hub/cap remover/installer combination tool to pry off the cap in a back and forth motion. The wheel skins can now be removed.
scientia non olet · About LEMON Manuals