LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 867 (Steering System - 2500 Hd & 3500 Hd) >> Linkage, Link And Coil >> End, Tie Rod, Link And Coil >> Removal >> RH - Drag Link To Tie Rod

RH - Drag Link To Tie Rod

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Drag Link, Steering, Link And Coil
GC0161598Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the tire and wheel.
  3. Remove tie rod to knuckle nut (1).
  4. Remove the drag link to tie rod.
  5. Loosen the nut/bolt on the tie rod adjuster sleeve (11).
    Fig 2: Identifying Tie Rod, Puller And Left Knuckle
    GC0108922Courtesy of CHRYSLER GROUP, LLC
  6. Remove tie rod (3) from the knuckle (2) and the drag link from the tie rod with (special tool #8677, Remover, Ball Joint) (1).
  7. Remove the tie rod end from the adjuster sleeve.
scientia non olet · About LEMON Manuals