LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 867 (Steering System - 2500 Hd & 3500 Hd) >> Linkage, Link And Coil >> End, Tie Rod, Link And Coil >> Installation >> RH - Drag Link To Tie Rod

RH - Drag Link To Tie Rod

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Verify that equal number of thread engagement exists on both ends of adjuster sleeve and that the adjuster sleeve clamps cover the threaded ends.

NOTE:

Prior to installing tapered end suspension components, clean male and female surfaces with brake clean.

Fig 1: Drag Link, Steering, Link And Coil
GC0161598Courtesy of CHRYSLER GROUP, LLC
  1. Install the tie rod (12) into the adjuster sleeve (8) and into the steering knuckle.
  2. Install the drag link (3) to the tie rod (12). Install the nut (2) and tighten to specifications. Refer to LINKAGE, LINK AND COIL, SPECIFICATIONS .
  3. Install the tire and wheels as necessary. Refer to WHEELS, STANDARD PROCEDURE .
  4. Remove the supports and lower the vehicle. Center the steering wheel and adjust the toe. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
    NOTE:

    Position the clamp on the sleeve so retaining bolt is located on the bottom side of the sleeve.

  5. After adjustment tighten tie rod adjustment sleeve clamp bolt (11) to specifications. Refer to LINKAGE, LINK AND COIL, SPECIFICATIONS .
scientia non olet · About LEMON Manuals