Stabilizer Link
WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Install links (3) to the axle bracket and tighten nut to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .
- Install links (3), retainers, grommets and nuts to the stabilizer bar. Hold the link shaft with a wrench and tighten the nuts to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .
- Remove the supports and lower the vehicle.