4500 And 5500

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Lower Ball Joint Nut

Courtesy of CHRYSLER GROUP, LLC

Position the steering knuckle (1) on the ball stud.
Install and tighten the lower ball stud nut (3) to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .

Fig 2: Upper Ball Joint
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Make sure the wheel speed sensor bracket (3) for the wire is installed between the knuckle and ball joint (2).
Install the upper ball joint (2) into the steering knuckle and tighten to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .

Fig 3: Upper Ball Joint Nut
Courtesy of CHRYSLER GROUP, LLC
Install and tighten the upper ball stud nut (1) to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .
Retorque the lower ball stud nut to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .

Fig 4: Hub/Bearing Bolts
Courtesy of CHRYSLER GROUP, LLC
Install the hub bearing and tighten the bolts (1) to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .

Fig 5: Identifying Wheel Speed Sensor & Mounting Bolt
Courtesy of CHRYSLER GROUP, LLC
Install the wheel speed sensor (2). Refer to SENSOR, WHEEL SPEED, FRONT, INSTALLATION .

Fig 6: Dust Shield
Courtesy of CHRYSLER GROUP, LLC
Install the dust shield (2) if removed.

Fig 7: Disc Brake Rotor, Hub Extension & Axle Shaft Nut
Courtesy of CHRYSLER GROUP, LLC
Install the disc brake rotor (1) and extension (2) to the hub/bearing.

Fig 8: Disc Brake Caliper Adapter & Bolts
Courtesy of CHRYSLER GROUP, LLC
Install the disc brake caliper adapter (2) and bolts (1).

Fig 9: Caliper & Components
Courtesy of CHRYSLER GROUP, LLC
Install the disc brake caliper (2) and tighten the bolts (1).
Install tie-rod or drag link end onto the steering knuckle arm.