Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

REPROGRAM THE POWERTRAIN CONTROL MODULE
1. Check for any related TSBs.
2. Verify the PCM is at the latest calibration (flash level).
  NOTE:
  An intermittent loss of power to the PCM without performing an ETC Relearn procedure may cause this DTC to set.
3. Flash the Powertrain Control Module per Service Information if any updates are available.
4. Start the engine.
5. Allow the engine to reach normal operating temperature.
6. Operate the accelerator pedal. (do not exceed 3500 rpm)
7. Test drive the vehicle for 10 miles on a flat road surface.
  Does this DTC reset?
  
  Yes
  - Replace and reprogram the Powertrain Control Module per Service Information.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Test Complete.