Diagnostic Test
WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
CHECK FOR AN ACTIVE DTC
NOTE:
If any voltage Stability Module 2 DTCs are present in the Body Control Module, diagnose and repair those DTCs before continuing with this test procedure.
- Turn the ignition on.
- With the scan tool, erase DTCs.
- Cycle the ignition on and off several times, leaving the ignition on for at least 20 seconds during each ignition cycle.
- Turn the ignition on.
- Monitor the scan tool for at least two minutes.
- With the scan tool, read DTCs and record on the repair order.
Is the DTC active or pending?
Yes
- Replace the voltage Stability Module 2 in accordance with the Service Information.
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .