LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 832 (3.0L Diesel - DTCS P050E-00 To P067B-00 - 1500) >> Diagnosis And Testing >> P064D-00-Internal Control Module 02 Sensors Processor Performance - Bank 1 >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. ACTIVE DTC 
    NOTE:

    If there are any other O2 Sensor DTCs present, perform the Diagnostics for those DTCs before continuing with this one.

    1. Turn the ignition on.
    2. With the scan tool, record all Freeze frame data.
    3. With the scan tool, erase DTCs.
    4. Turn the ignition off for 75 seconds.
    5. Turn the ignition on, run the engine to operating temperature
    6. With the scan tool, read DTCs.

      Did the DTC reset?

      Yes 

      • Go To  2

      No 

      • Perform to the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT DTC .
  2. O2 SENSOR 
    1. Turn the ignition off.
    2. Replace the Oxygen Sensor in accordance with the Service Information. Refer to SENSOR, OXYGEN, REMOVAL .
    3. Turn the ignition on.
    4. With the scan tool, erase PCM DTCs.
    5. Start the engine and run it until it reaches operating temperature.
    6. Test drive the vehicle under normal operating conditions.
    7. With the scan tool, read PCM DTCs.

      Does the scan tool display this DTC?

      Yes 

      • Go To  3

      No 

  3. POWERTRAIN CONTROL MODULE 
    1. Disconnect all PCM harness connectors.
    2. Disconnect all related in-line harness connections (if equipped).
    3. Disconnect the related component harness connectors.
    4. Inspect harness connectors, component connectors, and all male and female terminals for the following conditions:
      • Proper connector installation.
      • Damaged connector locks.
      • Corrosion.
      • Other signs of water intrusion.
      • Weather seal damage (if equipped).
      • Bent terminals.
      • Overheating due to a poor connection (terminal may be discolored due to excessive current draw).
      • Terminals that have been pushed back into the connector cavity.
      • Perform a terminal drag test on each connector terminal to verify proper terminal tension.

      Repair any conditions that are found.

    5. Reconnect all PCM harness connectors. Be certain that all harness connectors are fully seated and the connector locks are fully engaged.
    6. Reconnect all in-line harness connectors (if equipped). Be certain that all connectors are fully seated and the connector locks are fully engaged.
    7. Reconnect all related component harness connectors. Be certain that all connectors are fully seated and the connector locks are fully engaged.
    8. With the scan tool, erase DTCs.
    9. Using the recorded Freeze Frame and Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
    10. With the scan tool, read PCM DTCs.

      Did the DTC return?

      Yes 

      No 

scientia non olet · About LEMON Manuals