LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 810 (8HP70 Automatic Transmission (Service Information) - 1500) >> Heater, Transmission >> Installation >> Installation

Heater, Transmission: Installation: Installation

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the transmission heater (1) in place, being sure that the O-rings are seated.
  2. Install the three bolts into the transmission heater and torque to 25 N.m (18 ft. lbs.).
    Fig 1: Cooler Lines
    GC0154556Courtesy of CHRYSLER GROUP, LLC
  3. Connect the coolant lines (2) to the transmission heater.
  4. Connect the transmission lines (1) into the transmission heater and snap the lock into place.
    Fig 2: Left Side Transmission Line Bracket Bolt
    GC0154470Courtesy of CHRYSLER GROUP, LLC
  5. Install the left side transmission cooler line (1) bracket bolt 2) and tighten to 21 N.m (15 ft. lbs.).
    Fig 3: Right Side Transmission Line Bracket Bolt
    GC0154534Courtesy of CHRYSLER GROUP, LLC
  6. Install the right side lower transmission line (2) bracket bolt (1) and tighten to 21 N.m (15 ft. lbs.).
    Fig 4: Upper Transmission Line Bolt
    GC0154503Courtesy of CHRYSLER GROUP, LLC
  7. Install the right side upper transmission line (1) bracket bolt (2) and tighten to 21 N.m (15 ft. lbs.).
  8. If equipped, install the front propeller shaft.
  9. Fill the engine with coolant. Refer to STANDARD PROCEDURE .
  10. Fill the transmission with fluid. Refer to STANDARD PROCEDURE .
Fig 5: Transmission Heater
GC0154364Courtesy of CHRYSLER GROUP, LLC
scientia non olet · About LEMON Manuals