Valve, Exhaust Gas RECIRCULATION (EGR), 5.7L: Installation: Installation
WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- Position a new metal gasket between cylinder head (1) and valve assembly (3).
- Install two mounting bolts (2) and tighten to 20 ft. lbs. (27 N.m).
- Clean EGR tube where it joins EGR valve.
- Position new gasket between EGR tube flange and EGR valve assembly.
- Install two bolts (3) connecting EGR tube (4) to valve assembly (2). Tighten bolts to 20 ft. lbs. (27 N.m).
- Connect electrical connector (1) to EGR solenoid (2).
- Connect negative battery cable.
- Using a diagnostic scan tool, erase any previously recorded DTC's (Diagnostic Trouble Codes).