Diagnostic Test

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

STEERING WHEEL POSITION SENSOR-INTERNAL ELECTRONIC FAILURE

Perform any Service Bulletins that may apply.
The ABS Module is reporting internal errors from the SAS.
NOTE:
Before continuing, check the Steering Angle Sensor harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and Ground circuits.
Were there any problems found?

Yes
- Repair as necessary.
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
No
- Replace the Steering Control Module (SCM) in accordance with the Service Information.
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .