LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 779 (Electronic Control Modules (Service Information) - 1500) >> Module, Instrument Panel Cluster >> Removal >> Removal

Module, Instrument Panel Cluster: Removal: Removal

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the cluster bezel from the instrument panel. Refer to BEZEL, INSTRUMENT CLUSTER, REMOVAL .
    Fig 1: Instrument Cluster, Instrument Panel & Screws
    GC0154533Courtesy of CHRYSLER GROUP, LLC
  3. Remove the two screws (3) that secure the instrument cluster (1) to the instrument panel (2).
    Fig 2: Disconnecting/Connecting Instrument Panel Wire Harness Connector
    GC0154362Courtesy of CHRYSLER GROUP, LLC
  4. Pull the instrument cluster rearward far enough to access and disconnect the instrument panel wire harness connector (2) from the connector receptacles on the back of the cluster (1) housing.
  5. Remove the instrument cluster from the instrument panel.
scientia non olet · About LEMON Manuals