3.0L Diesel
WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- Loosely assemble the exhaust tailpipe (2) and clamp (2) to permit proper alignment of all parts.
- Position the exhaust tailpipe (2) for proper clearance with the underbody parts.
- Tighten all the clamp nuts to 65 N.m (48 ft. lbs.).
- Hang the tailpipe (2) onto the isolator (1).
- Check the exhaust system for contact with the body panels. A minimum of 25 mm (1.0 in.) is required between the exhaust system components and body/frame parts. Make the necessary adjustments, if needed.
- Remove the support and lower the vehicle.
- Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary. Refer to DIAGNOSIS AND TESTING .