Exhaust Gas Temperature Sensor 1/2
WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
The exhaust gas temperature sensor requires care when handling and installing. The exhaust gas temperature sensor is sensitive to knocks and bending. For this reason if the exhaust gas temperature sensor has been dropped, it must not be installed as damage to the sensor may have occurred. Do not remove from packaging until ready to install. Failure to follow these instructions may result in damage to the exhaust gas temperature sensor.
- Install the Exhaust Gas Temperature (EGT) sensor (3) and tighten to 47 N.m (35 ft. lbs.).
- Connect the front EGT sensor wire harness connector (2).
- Install the right front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .
- Install the right front tire and wheel assembly.
- Remove the support and lower the vehicle.
- Connect the negative battery cable.