3.0L Diesel Dual Exhaust
WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- Pre-assemble the muffler (2) and clamp (1) loosely to permit proper alignment of all parts.
- Hang the dual outlet muffler (2) on the isolators (4).
- Install the muffler (2) onto the exhaust pipe (3) and tighten the clamp to 65 N.m (48 ft. lbs.).
- Install the tailpipe assemblies. Refer to TAILPIPE, EXHAUST, INSTALLATION .
- Check the exhaust system for contact with the body panels. A minimum of 25 mm (1.0 in.) is required between the exhaust system components and body/frame parts. Make the necessary adjustments, if needed.
- Remove the support and lower the vehicle.
- Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary. Refer to DIAGNOSIS AND TESTING .