Section 767 (Engine Cooling System - 1500): Engine: Thermostat: Installation: 3.0L

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Thermostat Housing & O-Ring Seal

Courtesy of CHRYSLER GROUP, LLC

Install a new O-ring seal (1) onto the thermostat housing (2).

Fig 2: Thermostat Housing & Mounting Bolts
Courtesy of CHRYSLER GROUP, LLC
Position thermostat housing (2) onto the water pump.
Install two thermostat housing bolts (1). Tighten bolts to 11 N.m (97 in. lbs.).
Install upper radiator hose on thermostat housing (2).
Fill cooling system. Refer to STANDARD PROCEDURE .

Fig 3: Removing/Installing Engine Cover
Courtesy of CHRYSLER GROUP, LLC
Connect negative battery cable to battery.
Start and warm the engine. Check for leaks.
Install the engine cover (1).