LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 766 (5.7L Engine (Service Information) 1500) >> Cylinder Head >> Cover(S), Cylinder Head >> Removal >> Right

Cover(S), Cylinder Head: Removal: Right

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Battery Cables & Components
GC0155269Courtesy of CHRYSLER GROUP, LLC
  1. Remove the nut (1) and the negative battery cables (10, 11).
    Fig 2: Engine Cover
    GC0087996Courtesy of CHRYSLER GROUP, LLC
  2. Remove the air filter body (4). Refer to BODY, AIR CLEANER, REMOVAL, 5.7L .
  3. Remove the clean air duct (2).
  4. Remove the engine cover (1). Refer to COVER, ENGINE, INSTALLATION, 5.7L .
    Fig 3: Ignition Coil Electrical Connectors, Harness & Bolts
    GC0143844Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the ignition coil harness connectors (1).
  6. Disconnect the fuel injectors harness connectors.
  7. Position the engine harness (2) aside.
  8. Remove the ignition coil retaining bolts (3) and remove the ignition coils.
    Fig 4: Cylinder Head Cover Removal/Tightening Sequence
    GC0080292Courtesy of CHRYSLER GROUP, LLC
  9. Using the sequence shown in illustration, remove the cylinder head cover retaining bolts.
    CAUTION:

    Do not use harsh cleaners to clean the cylinder head covers. Severe damage to covers may occur.

    Fig 5: Cylinder Head & Cover
    GC0139403Courtesy of CHRYSLER GROUP, LLC
  10. Remove the cylinder head cover (1).
  11. Clean the sealing surface of the cylinder head (2) and cover.
NOTE:

The cylinder head cover gasket may be used again, provided no cuts, tears, or deformation have occurred.

scientia non olet · About LEMON Manuals