Damper, Vibration: Removal: Removal

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Engine Cover

Courtesy of CHRYSLER GROUP, LLC

Disconnect negative battery cable.
Remove the engine cover (1).

Fig 2: CAC Hose & EGR Air Flow Control Valve
Courtesy of CHRYSLER GROUP, LLC
Disconnect the CAC hose (1) from the EGR air flow control valve (2) and position aside.

Fig 3: Identifying Belt Tensioner & Belt
Courtesy of CHRYSLER GROUP, LLC
Remove the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Lock the engine 30 degrees ATDC. Refer to VALVE TIMING - STANDARD PROCEDURE .

Fig 4: Vibration Damper & Bolt
Courtesy of CHRYSLER GROUP, LLC
Lower the vehicle.
NOTE:
The crankshaft damper bolt is a left hand thread.
Remove bolt (1) and the vibration damper (2).