LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 751 (Body - Interior & Exterior - 1500) >> Interior >> Console, Overhead, Front >> Removal >> Removal

Console, Overhead, Front: Removal: Removal

WARNING: This page is about a different car, the 2015 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Electronic Overhead Module Components
GC0087703Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Using your fingertips, grasp the sides of the overhead console and pull straight down evenly to disengage the four snap clips.
    Fig 2: Overhead Console Harness Connectors
    GC0087704Courtesy of CHRYSLER GROUP, LLC
  3. Lower the overhead console from the headliner far enough to access the wire harness connectors.
  4. Disconnect the reading lamp wire harness connector (1).
  5. Disconnect the sunroof switch wire harness connector, if equipped.
  6. Disconnect the inferred temperature sensor wire harness connector (4), if equipped.
  7. Disconnect the power sliding glass wire harness connector (2), if equipped.
  8. Disconnect the Homelink® transceiver wire harness connector (3), if equipped.
  9. Remove the overhead console from the vehicle.
scientia non olet · About LEMON Manuals