Diagnostic Test

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

LOW COOLANT LEVEL
1. Diagnose all other DTCs before continuing.
2. Check the coolant system to make sure that the coolant is in good condition, at the proper level, and meets OEM specifications. Refer to DIAGNOSIS AND TESTING .
  Is the coolant level and condition OK?
  
  Yes
  - Go To 2
  No
  - Inspect the vehicle for a coolant leak and add the necessary amount of coolant. Refer to SPECIFICATIONS .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
ACTIVE DTC
1. Start the engine.
2. Allow the engine to reach normal operating temperature.
3. Test drive the vehicle under the conditions in which the fault originally set by reviewing the Freeze Frame data.
4. With the scan tool, read DTCs.
  Is the DTC Active or Pending at this time?
  
  Yes
  - Go To 3
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
CHECK COOLING SYSTEM OPERATION
1. Check the following cooling system components:
  - Verify condition and operation of the accessory belt and tensioner.
  - Verify proper airflow through the radiator.
  - Verify that the Thermostat is opening correctly.
  - Verify the correct coolant flow throughout the system.
  - During engine warm-up, monitor the coolant temperature and the operation of the Cooling Fan.
  Is the Cooling system operating correctly?
  
  Yes
  - Go To 4
  No
  - Perform the appropriate repairs.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
CHECK THE FUEL DELIVERY SYSTEM
1. Perform the CHECKING THE FUEL DELIVERY SYSTEM test procedure. Refer to DIAGNOSIS AND TESTING .
  Were any problems found with the fuel system?
  
  Yes
  - Perform the appropriate repair.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Go To 5
ENGINE MECHANICAL
1. Turn the ignition off.
2. Check for any of the following conditions/mechanical problems:
  - AIR INDUCTION SYSTEM - must be free from leaks.
  - ENGINE VACUUM - check the engine for vacuum leaks
  - ENGINE VALVE TIMING - must be within specifications
  - POWER BRAKE BOOSTER - no internal vacuum leaks
  - FUEL - must be free of contamination
  - FUEL INJECTOR - plugged or restricted injector; control wire not connected to correct injector
  Are there any engine mechanical problems?
  
  Yes
  - Repair as necessary.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Replace the EGR Temperature Sensor in accordance with the service information.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .