LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 ((Memory Seat Module (MSMD) - Electrical Diagnostics)) >> Diagnosis and Testing >> B1D9B-Seat Horizontal Front Stop Not Learned >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR SEAT POSITION SENSOR AND CIRCUIT PERFORMANCE DIAGNOSTIC TROUBLE CODES (DTCs) 
    1. Turn the ignition on.
    2. Using a scan tool, read DTCs.

      Does the scan tool display any seat position sensor or circuit performance DTCs?

      Yes 

      • Diagnose and repair all seat position sensor and circuit performance DTCs. Refer to Diagnosis and Testing .

      No 

      • Go To  2.
  2. TEST FOR INTERMITTENT CONDITION 
    1. Using a scan tool, record and erase DTCs.
    2. Move the seat switch in the full forward horizontal adjust position.
    3. Using a scan tool, read DTCs.

      Does the scan tool display DTC B1D9B-SEAT HORIZONTAL FRONT STOP NOT LEARNED?

      Yes 

      • Using a scan tool, perform the MSM Standard Routine.
      • Perform POWER SEAT SYSTEM VERIFICATION TEST. Refer to Standard Procedure .

      No 

      • The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
      • Perform POWER SEAT SYSTEM VERIFICATION TEST. Refer to Standard Procedure .
scientia non olet · About LEMON Manuals