Heavy Duty
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - WHEEL SPEED SENSOR |
| 2 - MOUNTING STUD |
| 3 - AXLE HOUSING |
- Raise and support the vehicle. Refer to Hoisting , Standard Procedure .
- Remove the brake line mounting nut and remove the brake line from the sensor stud.
- Remove the mounting stud (2) from the sensor (1) and shield.
- Remove the sensor (1) and shield from the differential housing (3).
- Disconnect the sensor wire harness and remove the sensor (1).