LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Anti-Lock Brake System (Abs) (Service Information)) >> Electrical >> SENSOR, Wheel Speed, Rear >> Installation >> 1500

SENSOR, Wheel Speed, Rear: Installation: 1500

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Wheel Speed Sensor, Bolt, Adapter, And Electrical Connector
GC0083404Courtesy of CHRYSLER LLC
  1. Insert the wheel speed sensor (4) in the brake caliper adapter.
  2. Install the sensor mounting bolt (1) and tighten to 24 N.m (200 in. lbs.).
  3. Reconnect the electrical wiring connector (3) to the sensor (4).
  4. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals