Valve, Short Runner: Installation: 5.7L

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Short Runner Valve Actuator Rubber O-Ring Seal

Courtesy of CHRYSLER GROUP, LLC

Install a new short runner valve actuator rubber O-ring seal (1).

Fig 2: Short Runner Valve Actuator Retaining Bolts
Courtesy of CHRYSLER GROUP, LLC
Position the short runner valve actuator, install the retaining bolts (1) and tighten to 5 N.m (44 in. lb.).

Fig 3: Intake Manifold Retaining Bolt Removal & Tightening Sequence
Courtesy of CHRYSLER GROUP, LLC
Install the intake manifold and throttle body as an assembly. Refer to MANIFOLD, INTAKE, GAS, INSTALLATION, 5.7L or MANIFOLD, INTAKE, GAS, INSTALLATION, 6.4L

Fig 4: Battery
Courtesy of CHRYSLER GROUP, LLC
Connect the negative battery cable (1).