Sensor, Oxygen: Installation: 6.4L

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: O2 Sensors & Electrical Connectors

Courtesy of CHRYSLER GROUP, LLC

NOTE:

Rear O2 sensors shown in illustration. Fronts similar.

Threads of new oxygen sensors are factory coated with anti-seize compound to aid in removal.DO NOT add any additional anti-seize compound to threads of a new oxygen sensor.

Install the O2 sensor (3, 5). Tighten to 50 N.m (37 ft. lbs.)
Connect the O2 sensor (1, 2) electrical connector.
Lower vehicle.