LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 696 (Fuel System - 2500 Hd & 3500 Hd) >> Fuel Delivery, 6.7L Diesel >> Tube, Fuel Tank Filler >> Installation >> Installation

Tube, Fuel Tank Filler: Installation: Installation

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Fuel Filler Tube Screws
GC0155473Courtesy of CHRYSLER GROUP, LLC
  1. Install the fuel filler tube and securely tighten screws.
    Fig 2: DEF Cap
    GC0155441Courtesy of CHRYSLER GROUP, LLC
  2. Install the DEF cap.
    Fig 3: Tank Fitting & Fuel Vapor Hose
    GC0161625Courtesy of CHRYSLER GROUP, LLC
  3. Connect the fuel vapor hose (2) to tank fitting (1).
    Fig 4: Remove/Install Tubes
    GC0157556Courtesy of CHRYSLER GROUP, LLC
  4. Install the ground wire (5) to frame rail and securely tighten nut (6).
  5. Connect the diesel fuel vent tube (2). Tighten the hose clamp (1) to 3 N.m (30 in. lbs.).
  6. Connect the diesel fuel fill tube (3). Tighten the hose clamp (4) to 3 N.m (30 in. lbs.).
  7. Install the left rear wheelhouse splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .
  8. Raise the vehicle.
    Fig 5: Fuel Tank Filler Tube
    GC0157552Courtesy of CHRYSLER GROUP, LLC
  9. Connect the DEF vent hose to filler neck tube (1).
  10. Connect the DEF filler hose to filler neck tube (2).
  11. Lower the vehicle.
  12. Connect the negative battery cable.
  13. Start the vehicle and check for leaks.
scientia non olet · About LEMON Manuals