Fascia, Front: Installation: Sport

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Upper Clips And Sport Fascia

Courtesy of CHRYSLER GROUP, LLC

Locate the fascia (1) over the upper surface of the bumper beam (2).
Position the center locator pin in the center of the fascia to the retainer hole and seat fully.
Pry or bend the outer ears of the fascia (1) around the headlamps and align to the fender (3).
Confirm that the fascia (1) and the bumper (2) are lined up correctly and seat the upper clips fully.
Install the grille. Refer to GRILLE, INSTALLATION .

Fig 2: Removing/Installing Sport Bumper Lower Fasteners
Courtesy of CHRYSLER GROUP, LLC
Install the four lower fasteners (2).

Fig 3: Screws, Fascia & Fender
Courtesy of CHRYSLER GROUP, LLC
Install the screws (1) attaching the fascia (3) to the fender (2).

Fig 4: Wheelhouse Splash Shield & Push Pins
Courtesy of CHRYSLER GROUP, LLC
Position the wheelhouse splash shield back and install the push pins (3).