LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 ((Cabin Compartment Node (CCN) - Electrical Diagnostics)) >> Diagnosis and Testing >> B168F-Front Fog Lamp Switch Circuit Stuck >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. TEST FOR INTERMITTENT CONDITION 
    1. Turn the ignition on.
    2. Turn the Headlamps on.
    3. Operate the Fog Lamp Switch several times.
    4. Turn the ignition on and wait 30 seconds.
    5. Using the scan tool, read DTCs.

      Does the scan tool display: B168F-FRONT FOG LAMP SWITCH CIRCUIT STUCK?

      Yes 

      • Replace the Headlamp Switch in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500.

      No 

      • Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
scientia non olet · About LEMON Manuals