LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 ((Cabin Compartment Node (CCN) - Electrical Diagnostics)) >> Diagnosis and Testing >> B1607-Headlamp Switch Input Circuit Low >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR ACTIVE DTC 
    1. Turn the ignition on.
    2. Turn the Headlamps on.
    3. With the scan tool, read the DTCs.

      Does the scan tool display this DTC as active?

      Yes 

      • Go To  2.

      No 

      • The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500.
  2. HEADLAMP SWITCH 
    Fig 1: Headlamp/Fog Lamp Switch Connector End View
    GC0091165Courtesy of CHRYSLER LLC
    1. Disconnect the Headlamp Switch harness connector.
    2. Turn the ignition on.
    3. Measure the voltage of the (L116) Headlamp / Fog Lamp Switch Signal circuit.

      Does the voltage read 5.0 volts?

      Yes 

      • Replace the Headlamp Switch in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500.

      No 

      • Go To  3.
  3. (L116) HEADLAMP / FOG LAMP SWITCH SIGNAL CIRCUIT SHORTED TO GROUND 
    Fig 2: Checking Headlamp/Fog Lamp Switch Signal Circuit Shorted To Ground
    GC0091166Courtesy of CHRYSLER LLC
    1. Turn the ignition off.
    2. Disconnect the Headlamp Switch harness connector.
    3. Disconnect the Instrument Cluster C3 harness connector.
    4. Measure the resistance of the (L116) Headlamp Switch Signal circuit to ground.

      Is the resistance below 5.0 Ohms?

      Yes 

      • Repair short to ground on the (L116) Headlamp / Fog Lamp Switch Signal circuit.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500.

      No