LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 667 (Electronic Control Modules (Service Information) 2500 Hd & 3500 Hd) >> Module, Ignition Node >> Removal >> Removal

Module, Ignition Node: Removal: Removal

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Switch Mounting Screws
GC0121041Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the dash end cap.
  3. Remove the steering column opening cover.
  4. Disconnect the wire harness connector from the Ignition Node Module (IGNM).
  5. Remove 4 screws retaining the IGNM to the panel.
  6. Remove the IGNM from the backside of the instrument panel.
scientia non olet · About LEMON Manuals