LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 667 (Electronic Control Modules (Service Information) 2500 Hd & 3500 Hd) >> Module, Fuel Pump Control >> Installation >> Installation

Module, Fuel Pump Control: Installation: Installation

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Fuel Pump Control Module
GC0154484Courtesy of CHRYSLER GROUP, LLC
  1. If removed, reposition the heat shield (3) onto the fuel pump control module mounting studs.
  2. Install the fuel pump control module (2). Tighten the nuts (4) to 10 N.m (89 in. lbs.).
  3. Connect the electrical connector (1) to the module.
  4. Lower the vehicle.
  5. Connect the battery negative cable.
scientia non olet · About LEMON Manuals